Make cleaning up dirty cloth diapers a breeze!   Easily clean other messes as well such as rinsing potty trainers, personal hygiene after childbirth, and more!

Rinse your diapers without the mess and you stay clean.  Our diaper sprayer comes complete with a variable-flow valve so your cloth diapers get clean very easily.

This diaper sprayer, available in white or chrome, installs in minutes - just a few simple steps!

Features

Your choice of White or Chrome handled Sprayer

4 feet of reinforced hose

Variable Flow On/Off Control T-valve

Built in check valve (one way)

Compression Connectors

Optional Wall bracket and screws included

1 year limited warranty

Detailed Instructions

Made in the USA!

Easy Installation

The Sprout Change Diaper Sprayer installs in less than 10 minutes with a standard wrench. Detailed diaper sprayer instructions:

1. Turn water supply Stop Valve clockwise so it is off. Empty tank reservoir by holding flush lever down.

2. Remove supply hose from supply tank (extra water will drip out).

3. Connect tank end of sprayer. Then connect the intake end of the sprayer to water source. Tighten both end 1/4 turn with wrench. Be sure that the hose is not crimped.

4. (Optional) Install wall bracket by drilling holes into wall where you would like it. If you prefer, 2-sided tape works as well.

5. Slowly turn water supply on and check for leaks. If needed, tighten joint until leaking stops. Test sprayer by turning the flow valve counter-clockwise. To turn it back off, turn it clockwise.

Note:  If your Stop Valve outlet does not have a 3/8” fitting you will need to get an adapter from your local hardware store.

For additional information or troubleshooting, please contact: 877-437-5973.

8/25/11